The innovative high-efficiency remote sprayer on our Wet & Forget Shower, Wet & Forget Indoor, and Miss Muffet’s Revenge bottles will make applying your Wet & Forget product even easier than you imagined.
Use these step-by-step instructions to attach your sprayer, and prepare to meet your new favorite household work-saver!
Our innovative bottle design has been winning heaps of praise as well as some prestigious industry awards.
The ergonomic design allows you to hold the bottle comfortably at your side, paired with our high-efficiency sprayer that puts out 65% more product with each squeeze than the average sprayer and stretches to reach even the toughest spots, is truly a winning combination!
The instructions below will get you started so you can put your remote sprayer to good use.
How to Attach your Sprayer
Attaching your remote sprayer is almost as easy as using it. Here are the steps:
- Remove the sticker that’s holding the flip cap on the top of the bottle in place. Open the flip cap.
- You will find the hose coiled inside of the handle part of the sprayer nozzle. Gently pull the hose out and extend it to its full length of approximately 36 inches.
- Firmly insert the red hose tip into the hole in the center of the cap on the top of the bottle. You should feel the hose tip snap into place.
That’s it! Now you’re ready to start enjoying the benefits of Wet & Forget Shower, Wet & Forget Indoor Mold + Mildew Disinfectant Cleaner, and Miss Muffet’s Revenge.
Note: Once you’ve attached the sprayer, be sure to store the bottle in an upright position to prevent any product from leaking out of the cap’s breather hole.
What’s your favorite Wet & Forget product? Tell us in the comment section below!